Real feedback from warehouse and retail operators who switched to EZLED fixtures.
Elena Navarro Diaz, Logistics Manager
“We replaced 24 metal halide units with EZLED Floodlight Pro 200W. The difference in monthly kWh was immediate — our electrician confirmed the drop. Loading bays are brighter and safer during night shifts.”
Antonio Herrera Castro, Retail Owner
“The 12W emergency panel fit our ceiling grid without any cutting. Self-test feature saved us a call-out fee — the log shows it passed every weekly check. Three-hour backup gives staff peace of mind.”
Elena Navarro Diaz, Facilities Engineer
“The 150W driver integrated with our existing BMS without extra wiring. We now dim high-bays to 40% during low occupancy — projected annual saving of €1,200 on that zone alone.”
Antonio Herrera Castro, Workshop Supervisor
“Six months in and not a single flicker. The aluminium housing stays cool even after 10-hour runs. We had to replace two old fittings per year — zero replacements so far.”
Elena Navarro Diaz, Electrical Contractor
“Installed 12 drivers in a distribution centre near a substation. A grid spike hit last month — all drivers survived, while a nearby non‑EZLED fixture blew. The 10kV rating is real.”
Antonio Herrera Castro, Store Manager
“The 4000K colour matches our ceiling lights exactly — no patchy emergency glow. Customers don’t notice it until a drill test, then the exit path is clearly lit. Simple to reset after test.”
All wattage ratings are measured at the LED driver output under nominal load. Actual power draw may vary by ±5% depending on input voltage and ambient temperature. The EZLED Floodlight Pro 200W, for example, draws between 190W and 210W under normal operating conditions.
Lumen figures are based on initial measurements at 25°C after a 100-hour burn-in period. Over the product’s lifetime, output gradually decreases — typically by no more than 10% after 50,000 hours. The 26,000-lumen rating for the Floodlight Pro 200W is the initial value.
The 3-hour backup rating applies to a fully charged battery at 20°C ambient temperature. Cold environments (below 5°C) can reduce runtime by up to 20%. The EZLED Emergency Panel 12W automatically switches to battery mode within 0.5 seconds of mains failure.
IP65 means the fixture is fully protected against dust ingress and low-pressure water jets from any direction. It is not designed for submersion or high-pressure cleaning. The Floodlight Pro 200W is suitable for uncovered loading bays and warehouse exteriors but should not be placed in areas prone to flooding.
The EZLED Smart Driver 150W supports DALI-2 protocol and is compatible with most standard DALI-2 controllers. It does not support 0-10V or PWM dimming. For best results, use a certified DALI-2 control system. Surge protection is rated for 10kV common mode and 6kV differential mode.